Times aren't being recordedUpdated 2 months ago

If times are not being recorded, it may be due to the following settings. We recommend turning all these settings off to confirm basic operation.

In Beam Start: When on, the athlete must block the lasers for one second to initialize. Timing begins once they leave the lasers.

Trigger Start: When on, the timer will only begin when the manual trigger start is initiated from the Home unit.

In Beam + Trigger Start: With both these settings enabled, the athlete must be blocking the lasers (for at least one second) to then use the manual trigger start.

Spectate Mode: In Spectate Mode, the sensors from that device are not used. This means that additional Link units need to be connected on the same channel.

This assumes the following are setup correctly:

Home / Link: There is only one Home unit, and any additional units are on Link

Channel: All devices are on the same channel

Laser Setup: All receivers have accompanied sender laser properly aligned.